1. Break-in period

The wear period of the motorcycle is a very critical period, and the running-in of the first 1500 kilometers of the newly purchased motorcycle is very important. At this stage, it is recommended not to use the motorcycle at full load, and the speed of each gear should not exceed the limit of that gear as far as possible, which can improve the service life of the motorcycle.

2. Preheating

Preheat in advance. When riding a motorcycle in summer, it is generally better to warm up for about 1 minute, and more than 3 minutes in winter, which can protect various parts of the motorcycle.

When the motorcycle warms up, it should be carried out at idle speed or at low speed with a small throttle. During the warm-up, it can be used with the throttle and throttle to maintain the warm-up without stalling, and the warm-up time should not be too long. When the engine has a little temperature, it can also pull the throttle first (to prevent stalling) and drive slowly at low speed. During the warm-up, the throttle can be pulled back gradually and completely to run normally depending on the stable operation of the engine. Don’t bang the car with a big throttle when preheating, which will increase the engine wear and may even cause serious failure.

3. Cleaning

When riding a motorcycle, please pay attention to frequent cleaning to reduce the accumulation of dust on the motorcycle and improve the use efficiency of the motorcycle.

4. Add lubricating oil

The replacement of motorcycle oil should mainly consider mileage, frequency of use, refueling time and oil quality. The actual maintenance is mostly based on mileage. Under normal circumstances, it is recommended to replace the motorcycle oil every thousand kilometers according to the running-in period of the new car. If the running-in period is exceeded, even for ordinary minerals, the lubricant we add to the engine can remain within 2000 km.

5. Open the switch without emergency

When you are ready to ride a motorcycle every day, first turn on the switch of the motorcycle without hurry. First step on the pedal lever for several times, so that the cylinder can absorb more combustible mixture, then turn the key to the ignition position, and finally start the car. This is especially suitable for motorcycle starting in winter.

6. Tires

Motorcycle tyres, which come into contact with various roads every day, are consumables and are often damaged by stones and glass. Their performance status directly affects the driver’s handling and comfort of the vehicle. Therefore, checking the motorcycle tyres before riding can help improve the driving safety factor.